Aurora Inverter Monitoring Done Quick

Last time I set up inverter monitoring for my Aurora solar inverter, it had a lot of moving parts. I had a RaspberryPi ModelB hosting utilities writing to CSV files, which were periodically scooped up by a monitoring service. The monitoring service had a bit of setup and a few issues, but in the end it would get the data up to

This time around I decided to cut out all the bullshit and write to the PVOutput API with as little fuss as possible.

Note that to set all this up you will require a free account on PVOutput, and you will need to set up an API Key. You will also need to add your solar details which will give you a system Id.

Curtronics Aurora

Grab this great little utility - Curtronics Aurora. Download, unzip, and install:

tar -xf aurora-1.9.3.tar.gz
cd aurora-1.9.3
sudo make install

At this point you should try a query and see if you can contact the inverter (keep in mind if it is dark outside the inverter is probably powered down).

Try the following command:

/usr/local/bin/aurora -a 2 /dev/ttyUSB0 -Y15 -e

If you are not having any luck, check if /dev/ttyUSB0 is correct (this is your usb-to-serial device). You should be able confirm it by reading through your start up messages with dmesg.

Save this script in your home folder as

If you are using the default pi user, the path will be /home/pi/

Make sure you set execute permission: chmod 755


# configuration
apikey="your api key here"
system="your system Id here"

rd=$(date +%Y%m%d)
rt1=$(date +%H)
rt2=$(date +%M)
solarout=`/usr/local/bin/aurora -a 2 /dev/ttyUSB0 -Y15 -e -c | awk '{printf $1}'`
solarwatts=`echo ${solarout} | sed -e "s/\.//"`

# only make the request if we have a value from the inverter
if [[ ! -z $solarwatts  ]]; then
    result=`curl -H "X-Rate-Limit: 1" -H "X-Pvoutput-Apikey: ${apikey}" -H "X-Pvoutput-SystemId: ${system}" ${url}`
    if [[ $result == *"OK"* ]]; then
        echo "${rd} $(date +%H:%M) : API call successful, power output: ${solarout}"
        echo "${rd} $(date +%H:%M) : API call failed, ${result}"
    echo "${rd} $(date +%H:%M) : Inverter communication failure"

Cron Job

Edit your crontab (using crontab -e) and add the following record:

*/5 5-18 * * * /home/pi/ >> /home/pi/solar-log.txt

This cron task will run the solar logger every 5 minutes between the hours of 5am and 6pm. You may want to adjust those times depending on your latitude.

This will give you a solar-log.txt file with entries like this:

20191201 18:25 : API call successful, power output: 20.373
20191201 18:30 : API call successful, power output: 20.373

Once you start seeing successful API calls you should be able to see your shiny new chart on PVOutput.

pvoutput live output chart


If you are having issues, check the permissions on the aurora binary (755 should work).